Allt Nytt | Kalender | Racerbanor | Arrangörer | Forum | Varvtider/Loggar |
Skruva banåkabil Lambda pectel | 2 besök senaste veckan (244 totalt) |
LZA09-e1 heter en lambdasond som en säger han använder på pectel
L2/H2 verkar det numret oxå kallas verkar det som. Undrar för att jag oxå hört att det måste vara en speciell lamdasond. Så nu vet man inte vad som är sant. Jag har pectel SQ6 styrsystem _________________ emil andreasson |
Här är en man från en konversation på nätet då han använt sådan innan han bytte och det fungerade vad jag förstår
Hello Everyone, I have a fairly particular problem on my SQ6, I replaced the lambda probe (LZA09-E1) with a new twin probe, (I have not changed any parameter of the configuration assuming that the new probe respects the values of the old one)I don't have much experience on Pi Cal Tool, but I see that with the engine off the probe gives a value of "1", during start-up and with the engine running at idle speed the value always remains "1"moving the car the value drops to "0.75", the engine has very limited performance and I have a large amount of unburned petrol from the exhaust and despite the engine being cold (water temperature 30 °) the cooling fan is always running , I state that before the replacement of the lambda everything was perfectly fine.Many thanks to anyone with advice. _________________ emil andreasson |
Skruva banåkabil Lambda pectel | 2 besök senaste veckan (244 totalt) |